PDA

View Full Version : Looking for a v-neck vest pattern


tdc
12-06-2006, 09:53 AM
Hello again!

I'm ready to "up my game" with my knitting and take on a project more complex than a scarf/blanket! I'm thinking about doing a simple sweater, and thought perhaps someone might have a pattern for a women's v-neck sweater vest? I would like to knit something very plain, no cables or elaborate stitching at this point.

And I guess I had better learn how to join fronts and backs of things!

thanks for any input!

tdc

ctmax
12-06-2006, 10:49 AM
I'm thinking of making this one myself. http://knitty.com/ISSUEwinter04/PATTleftovers.html

:waving:

knitqueen
12-06-2006, 11:23 AM
I'm doing the above linked 'leftovers vest' from knitty at the moment and so far it's been a well written, easy to follow pattern. I'd recommend it.

ctmax
12-06-2006, 12:38 PM
What size did you make? I have a 40" bust, but it says the finished size on the vest would be 38". When I pull my tape measure that small it seems so tight. If I go up one size then the finished measurement would be 42" which I think would be to loose. I am having a hard time deciding which size I should make because I would like it to be a little fitted, but I'm not sure if it was 38" I could even get it on. :shrug:

knitqueen
12-06-2006, 01:13 PM
I hummed and hawed about the size too. I am a 36" bust, actually probably a bit more than that, and a D cup so I was very anxious about making the 36" size because it only finished at 34". I understand that it's supposed to be snug fitting but I didn't want it so tight at the bust that the knitting had to stretch out in order to fit. I'm not one for super tight clothes to begin with but I still wanted it to be flattering. So I decided on the next size up, the one that finishes at 38". I've been nervous about it all along but now that I'm finished the entire back and the front up to the armholes and can measure it, I see that my gauge was a bit tighter overall than when I did my swatch and it actually measures about 36" across at the chest which will be just right for me. It's too bad though that there aren't a few more in between sizes.

tdc
12-07-2006, 09:45 AM
holy smackers, that pattern looks hard! but I guess I have to start somewhere. After all, I can't just knit blankets, hats and scarves for the rest of my life! Anybody have a recommendation of what a good starter intermediate project might be to prepare me for this very cool vneck vest? Thanks!

ctmax
12-07-2006, 10:37 AM
I think you knit this in the round all the way up to the armpits and the only seaming you have is the shoulders. I don't think it looks that hard, you can do it. :D

knitqueen
12-07-2006, 11:14 AM
It's not hard! If you know how to cast on, bind off, increase/decrease, and knit in the round, you can do it!! The hardest part is going to be all the weaving in of ends from the colour changes :teehee:

HamburgKnitter
12-07-2006, 11:30 AM
I've had this very simple vest pattern bookmarked for quite awhile:

http://www.dailyknitter.com/michelle.html

HamburgKnitter
12-07-2006, 11:36 AM
Oh, and check through these patterns, for inspiration if nothing else. You can also up the skill level to intermediate if the patterns are too simple for you.

http://www.berroco.com/skill_fr/fr_easy_01.html

After knitting two scarves and a hat I tackled a turtleneck (the pattern called Doreen from the easy list) and it turned out wonderfully. So if you like the pattern, that is also a possibility.

mwedzi
12-07-2006, 01:12 PM
If you wonder about size, try measuring a sweater that you already have whose fit you like and seeing what that measures to. I always prefer to knit something smaller than my actual bust size.

ctmax
12-07-2006, 03:22 PM
I plan on knitting this in one color, so I won't have that many ends to weave in. :happydance:

knitqueen
12-07-2006, 03:59 PM
It would be great in a solid colour too, and you're right, very few ends to weave in! I'll post a pic of what I have so far this afternoon.

knitqueen
12-07-2006, 04:06 PM
This is what I have so far. As you can see the back is finished, and I'm almost finished the right front as well. Then just the left front, neck and armbands, and weave in all of those evil ends (which you can see some of on the pic) :shock:

ctmax
12-07-2006, 10:03 PM
That looks so good :cheering: Did you double strand for the ribbing like the pattern calls for?

knitqueen
12-07-2006, 10:12 PM
Oh yeah, I was going to mention that....I didn't, at first. I did a single strand with the same needle that I was going to use for the rest (size 6). I felt that the double strand would be too bulky for my liking, but the single strand did NOT look good. The cast on # of stitches accounts for that extra bulk and larger needle size for the ribbing, so if you don't do it the lower edge will be way too small. I didn't want to take all that I'd done apart so I inserted a needle into a destination row on one of my lower stripes and from there worked back down to the bottom edge with a double strand for the ribbing and a size 8 needle. I do NOT recommend doing it this way though, I'd say do the double strand right from the start like the pattern says and it will look great. I'm very happy with it now.

I just finished the right front and joined the right shoulder. I'll get the left front done this evening and then the majority of the actual knitting will be done!! :happydance:

ctmax
12-08-2006, 12:05 PM
I'm still waiting on my knitpicks order so I can start this vest :nails: How bulky is the bottom? because I wasn't going to double strand this part, but now you say it doesn't work unless you double strand.

knitqueen
12-08-2006, 12:18 PM
If you don't double strand you will have to make your cast on larger. If you read the pattern closely, for example in the third size which is the one that I made, the original cast on for the ribbing is 144sts, and by the time the ribbing is finished you are up to 180sts when you start using a single strand. The smaller cast on takes into account the bulkier knit and the larger needle size. Make sure you consider that if you decide to single strand. If I was going to single strand the ribbing I think I'd start off by casting on 180sts (for the size I made).

The ribbing is bulky, but it seems to suit the pattern.

gardenmommy
12-08-2006, 03:52 PM
In The Knitter's Handy Book of Patterns (http://www.amazon.com/Knitters-Handy-Book-Patterns-Multiple/dp/1931499047/ref=pd_bxgy_b_img_b/002-6688220-7228831) by Ann Budd there is a vest pattern where you enter your gauge (3 to 7 sts/inch) and size 36 to 54 inches and the pattern is calculated for you, and you can do V-neck with different edgings (ribbing, rolled, etc.)

ctmax
12-08-2006, 11:12 PM
would it work to only hold one strand, but still use the bigger needle size? :shrug: I'm not sure I could figure out the math from going from the ribbing to the rest of the vest.

knitqueen
12-08-2006, 11:49 PM
It would be better than what I did, but like any project when you use thinner yarn than the pattern calls for (1 strand vs. 2 strands) you won't get as wide a piece as you're supposed to. Why don't you experiment a bit - make a swatch of one strand in 3x3 ribbing for something like 24sts wide, and make another swatch with the same # of stitches but with 2 strands and see how they compare. That might give you a better idea.

For what it's worth, I didn't think I'd like the bulky ribbing at all but I actually really like how it's coming together.

knitqueen
12-09-2006, 12:40 AM
The front is done!! :cheering: :cheering: And I've conveniently tucked all those ends in for the picture :teehee: . Now I'm off to start weaving them in :sleepy:

tdc
12-12-2006, 10:47 AM
thank you to everyone for the great ideas and encouragement! I'm gonna "go for it"!!!

Hamburgknitter, besten Dank fuer die verschieden Mustern! :muah:

ctmax
12-19-2006, 06:32 PM
knitqueen I would love to see your vest if you have finished it! :waving:

CounselorScarf
01-06-2007, 10:37 PM
Hi there. I'm new to this forum and new to knitting too. I started knitting right after Thanksgiving last year and had never knit at all before that.

I clicked on the link in a previous post (referencing this vest (http://www.dailyknitter.com/michelle.html)) and I don't really understand the instructions. So far all I've made is just a couple of simple scarves.

The instructions begin with K2P2 which I recognize as being "mistake rib" from a scarf that I have in progress. Is that right? Does this same knit pattern make something else too? (or it because it is an even number of stiches)

When it says to bind off to shape arm holes ... well I have a hard time visualizing that ... what happens ... I'm confused. Do you bind of just the required number of stiches and knit the rest or are you still working in stockinette or something else?

Thanks in advance for your help.

Melody

ctmax
01-07-2007, 07:01 PM
Hi I will try to help you. It says to rib in K2 P2 for 4 rows. Then you would switch to stockinette till it's time to bind off. You would just bind off the number of stitches it tells you, and you would continue in stockinette. You would be shaping the arm holes. When the piece measures to whatever size you are making you would bind off the remaining stitches. Hope that makes a little more sence now. :D

knitqueen
01-07-2007, 08:11 PM
knitqueen I would love to see your vest if you have finished it! :waving:

Not done yet :oops: I've been so busy with Christmas, and now my Sockintine's Sock Swap project, haven't gotten around to the last finishing of the vest. All I need to do is the armhole edging, which I could do in an evening probably, just haven't gotten around to it. I hope to finish it soon though! :D

aineepooh1
01-08-2007, 04:21 AM
HamburgKnitter
I checked out your pattern link and that vest looks absolutely DOABLE it looks (deceptively?) simple and very like to be attempted
thanks for postint it
:cheering: :cheering: Ainee

CounselorScarf
01-08-2007, 09:38 PM
Seems like it is difficult to find very simple v-neck women's vest patterns. I will have to give a try at the one listed by hamburgknitter. So many things I want to try - I could have 20 things going at once!

Has anyone made any men's patterns for themselves? I really like the simplicity and style of this v-neck vest:
http://www.berroco.com/exclusives/peter/peter_easy.html

^but I'm wondering if that would look unisex enough. I'd really like a women's vest pattern very much along the lines of that vest above. I might just try that one though it scares me quite abit! LOL.

Melody

momwolf
01-10-2007, 08:42 PM
Here are some vests
http://www.freepatterns.com/fp_pdfs/Other/Knitting/Folk_Art_Vest.pdf
http://www.tkga.com/pdf/AlpacaVest.pdf
http://www.lionbrand.com/patterns/kkc-vest.html
http://web.archive.org/web/20000416215930/http://www.thesmartyarns.com/ladysknit.htm
http://www.ample-knitters.com/mid-xpress.html
http://www.yarn-store.com/knitted-vest-patterns.html