PDA

View Full Version : Need help with Flip-Top Mittens


Kittyangelgirl
12-06-2007, 02:12 PM
First off I'd like to say hello, I'm new here. :)

Now, I'm making these flip-top mittens. The page I'm stuck on is in the attachment. It's a little blurry, but hopefully you can still read it.

This project is knitted on straight needles, and apparently sewed up once it's done.

I'm stuck on this one part. I have finished knitting the thumb, while the hand parts are on stitch holders. Here's the part:

Return hand stitches to needle if you placed them on holders. Rejoin yarn with right side facing to beginning of thumb gap, pick up and knit 3 stitches from base of thumb, knit to end-40 stitches.

If I knit those two hand parts together over the thumb, my thumb doesn't fit well in the glove, I end up getting like 2" of thumb sticking out! (which should not be the case since the thumb is the correct length.) But if I knit across where the side that's supposed to be sewed up later, it gets too tight on the needle because I'm knitting flat instead of knitting in the round.

I'll post pics of it if you need them

Please help knitsters!

suzeeq
12-06-2007, 02:35 PM
You don't just join the hand sts together, you'll be picking up 3 sts from the bottom of the thumb sts which joins the thumb to the hand.

Kittyangelgirl
12-06-2007, 02:42 PM
I still don't quite understand it, if I pick up three sts along the bottom of the thumb, then continue to knit the other hand (I presuming) Won't that make the thumb hole smaller or even close it up?

suzeeq
12-06-2007, 03:00 PM
You have the hand so far, then a tube for the thumb that's kind of flopping around, right? If you've made the thumb large enough it won't close it up. It should look somthing like this:

\ |
|
Picking up sts will close up the gap between the thumb and the hand sts.

Sandi
12-08-2007, 09:23 PM
Please let me know how you make out with these! My son wants me to knit him some.
:knitting: