how do i make a sweater pattern bigger??????????
I have a sweater pattern.It is a shawl collared cardigan i would really like to make.the problem is the pattern only goes to size 1x and i need it to be a 3 or 4x.can anyone please tell me how to make it bigger? you can see the pattern at
when you get on the page go up to the search box and put in 20061127 and that well take you to the page the sweater is on.
thanks to all
p.s.also i am having problems with my bamboo needles.what can i do to them to make the yarn run smooth over them again???
Geeze, with WoolEase chunky (or thick and quick) you should be able to go up to size 10.5 or even 11 needles and follow one of the pattern sizes they have.
There's a couple ways to fudge the pattern.
Use another size, like I suggested above. You figure out how many stitches/inch you get with your yarn and needles, and multply that by how many inches around you need. See if that number is close to the total stitches for front and back for one of the sizes listed in the pattern. You may have to adjust length on body, sleeves and armhole, but most patterns tell you knit for X inches anyway, so just make sure you use your tape measure frequently.
The other way is to look at the number of stitches difference between sizes. Say for the Large you CO 70, and for 1x it's 78. So if you need a 3x, figure that's 2 sizes larger than 1x and you need 16 stitches more than that. Check to make sure that will be big enough as in the first example above. If that's how you want to go, do the same for the sleeves and everywhere it mentions number of stitches.
ETA: I just realized that it's a free pattern and actually looked at it. D'oh. You could use size 11s I bet, and use a combination of larger needles and the stitch/size ratio, too.
If you have PC (not Mac) and want to determine new stitch/row counts, this small program is great.
http://www.cara4webshopping.com/cara...comp.htm - 14k
Input orig gauge (whatever your swatch is giving you as this allows for any sz ndl, any weight yarn...so doesn't have to match orig pattern). Then determine how many inches you need, for instance, at lower edge so you'll have new CO figs. Just Refresh to have it tell you new calcs. The 'Shaping' option allows you to structure sleeves, necklines to fit your individual figure. Just make sure to write down the old/new numbers and make note of adjusted figs on your schematic.
|All times are GMT -4. The time now is 09:01 AM.|