View Single Post
Old 10-31-2009, 01:22 PM   #4
carbar
Casting On
 
Join Date: Oct 2009
Posts: 6
Thanks: 1
Thanked 0 Times in 0 Posts
Panel A (worked over 16 sts)
Row 1 P3, k2tog, k3, yf, k3, skpo, p3
Row 2 K3, p4, [k1, p1] into yf on previous row, p4, k3
Row 3 P3, k2tog, [k2, yf] twice, k2, skpo, p3
Row 4 K3, p10, k3
Row 5 P3, k2tog, k1, yf, k4, yf, k1, skpo, p3
Row 6 As row 4
Row 7 P3, k2tog, yf, k6, yf, skpo, p3
Row 8 As row 4
Row 9 P2, k2tog, yf, k8, yf, skpo, p2
Row 10 K2, p12, k2
Row 11 P1, k2tog, yf, k10, yf, skpo, p1
Row 12 K1, p14, k1
These 12 rows form the patt and are repeated throughout

Panel B (worked over 6 sts)
Row 1 K6
Row 2 P6
Rows 3 and 4 As rows 1 and 2
Row 5 C6F=sl next 3 sts onto cn and hold in front of work, k3, then k3 from cn
Row 6 P6
Rows 7 and 8 As rows 1 and 2.
These 8 rows form the patt and are repeated throughout

Back
Cast on 114 sts.
Row 1 P1, work across 1st row of panel A, p1, *work across 1st row of panel B, p1, work across 1st row of panel A, p1; rep from* to end.
Row 2 K1, work across 2nd row of panel A, k1, *work across 2nd row of panel B, k1, work across 2nd row of panel B, k1; rep from * to end.
These 2 rows set the postion of the patt panels. Work a further 6 rows, working correct patt rows. Change to circular needle.

Shape sides
Inc and work into patt one st at each end of the next row and 23 foll alt rows, working first and last 6 sts in panel B, the next 1 st at each side in reverse st st, the next 16 sts at each side in panel A and the final 1 st at each side in rev St st. 162 sts. Work 1 row, so ending with a WS row.

This is the pattern up to where I need help with shaping the sides. Can anyone help?
carbar is offline   Reply With Quote