View Single Post
Old 08-26-2011, 07:15 AM   #2
apthornton
Casting On
 
Join Date: Aug 2011
Posts: 1
Thanks: 1
Thanked 0 Times in 0 Posts
I had the same problem on my 700. The most likely problem is your sponge bar (called the needle retainer in the manual). This holds the needles down and is the most common cause of machine knitting problems. To check your sponge bar, insert a pencil into one side of the machine and pull the bar out of the other side. There should be about 1 cm of sponge. If it is flat, this is most likely your problem.
apthornton is offline   Reply With Quote