View Single Post
Old 09-07-2006, 09:31 PM   #2
AlanCrawford
Ribbing the Cuff
 
AlanCrawford's Avatar
 
Join Date: Jun 2006
Location: PA
Posts: 29
Thanks: 0
Thanked 0 Times in 0 Posts
cross-stitch
in cross-stitch and needlepoint you leave yourself a good size tail, then as you start making your stitches you weave the tail in. when it comes time to stop, just weave the end back into the stitches.



Anchoring the thread
This is the most common method of starting off your stitching. When making your first stitch, push the needle up through the fabric and leave about a 5cm(2in) length at the back of your work. As you work the first few stitches, this length of thread can be covered so that the stranded cotton is secured firmly in place.




The loop method
If you are stitching with an even number of threads then this is a great method for achieving really neat results. To use the loop method, cut twice your normal length of thread, separate out one strand (if the design would normally require two) and fold the thread in half. Place the cut ends together and thread through the needle, leaving a loop hanging at the other end. Bring the needle up through the fabric to make the first half of the cross stitch, and then push the needle back down through catching it through the loop as you do so. Pull the thread being careful to make sure it's not too tight, and you will find that you stitch is secure
__________________
Nobody tells us how to be men. We just are.

According to Wikipedia, the online dictionary:
"Originally a male-only occupation, the first knitting trade guild was started in Paris in 1527. Knitting became a household occupation with the growing popularity of knitted stockings and by the end of the 1600s, one to two million pairs of stockings were exported from Britain to other parts of Europe."
AlanCrawford is offline   Reply With Quote