View Single Post
Old 01-27-2007, 02:37 PM   #3
nuknitter
1st Leg of the Journey
 
nuknitter's Avatar
 
Join Date: Nov 2006
Location: on the road, again...
Posts: 234
Thanks: 15
Thanked 18 Times in 16 Posts
Are you cabling on the correct row? I couldn't figure out how to do reversible cabling (cables that show up on both wrong and right sides of the work) until I read that you should cable on odd # row repeats (e.g, cable every 7th row). Very cool!

So I infer that this means if you want your cables to only show up on one side consistently (i.e., on the 'right' side), that it should be on an every even # row repeat (e.g, every 8th row).

Hope this helps!! Good luck, been there, done that ....

~jude
__________________
Two wrongs don't make a right, but three rights make a left.
nuknitter is offline   Reply With Quote