View Single Post
Old 06-08-2007, 11:52 PM   #2
suzeeq
Knit On!
 
Join Date: Aug 2006
Location: Montana
Posts: 27,765
Thanks: 160
Thanked 6,450 Times in 6,035 Posts
Send a message via Yahoo to suzeeq
Quote:
WHERE exactly do I join the new yarn? I know that i could just knit the yarn without joining it, and then and weaving the end in (and if i dont get any answers then i will do just that)
That's exactly what you're supposed to do. Knit the first set of stitches, place the next set on a holder. Then take a new yarn end and begin knitting with it, leaving about 6" of tail. It won't pull out, though it may be a little loose for a coupla rows. After you're done with the whole sweater (sounds like you'll be picking up sts for a neckband) you can weave in the tail and cut it; you don't need to weave it for 6".

sue
suzeeq is offline   Reply With Quote
The Following User Says Thank You to suzeeq For This Useful Post:
MaleKnitter (07-02-2007)