I did a swatch for the tank I am going to knit. I had the guage absolutely perfect before I blocked the swatch. I am using 100% peruvian highland wool ( Wool of the Andes) by knit picks. The pattern is Butter by Melini Melini Designs. The pattern calls for 6 stitches per inch and 7 and 1/2 rows per inch. After I blocked it I am still right on for the 7 and 1/2 row per inch but the stitches are only 5.5 per inch. that 1/2 a stitch difference per inch seems extremely minimal to me as it means I would be out less than one millimetre per inch. But when I figure it out over all with casting on 180 stitches it would mean that I would be about 15 stitches too big after blocking.
Now if I go to a bigger needle will it wreck the 7 and 1/2 rows per inch? I am not sure if this part matters so much as it says stitches per inch are more important to fit correctly.
You need to use a smaller needle, your stitch gauge grew (less sts per inch means the sts are larger). Even if your row gauge changes it won't be enough to affect the lengths which are usually given in inches anyway. You knit to 12" say, whether you have 7½ rows per inch or 7, use the tape measure instead of counting rows.
oh thank you, I would have mistakenly knitted a new swatch with a bigger needle. I did very well in math at school so I can't believe how much of a goof I made on that one! Well on a good note that means I get to try out the harmony needle sample of size 6 that I bought! thanks so much for straightening that out for me. We are very fortunate to have a site such as this as I can imagine how frustrating things must have been years back when the ability to solve an issue wasn't available at the touch of a button.
I am now wondering if I should just knit the tank with the size 7 needles anyway. The reason is that I feared the tank would be too big at 5.5 stitches per inch. Now I know it is the opposite. The tank is supposed to hug the body. I am about the size of the lady in the picture and often times smaller. (my weight goes down more than up) It says that it is very easy to try the tube on so I am wondering if I should start knitting it and just try it on after a couple of inches, almost treating it as a swatch. If it is too snug then go to bigger needle and start over. How does this sound?
Last edited by Christinechrstms1 : 06-09-2012 at 05:59 PM.
Reason: added words
A couple of inches might not be quite long enough to get an accurate measurement. You're thinking the wrong way again - at 5½ sts per inch you'd get a larger size. The size 6s at 6 sts per inch would make a smaller one. Or you could work on the 7s and make a smaller size.