Reply
 
Thread Tools Display Modes
Old 07-19-2010, 07:35 PM   #1
lovebug0702
Casting On
 
Join Date: Jul 2010
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
My scarf keeps getting wider
I have just started knitting. I am knitting a scarf and it keeps getting wider. I can't figure out what I am doing wrong. Help!
lovebug0702 is offline   Reply With Quote

 

This advertising will not be shown to registered members. Join our free online community today!

Old 07-19-2010, 07:54 PM   #2
MGM
Turning the Heel
 
MGM's Avatar
 
Join Date: Sep 2008
Location: Beautiful New England
Posts: 590
Thanks: 123
Thanked 291 Times in 227 Posts
Sounds like you might be forgetting to drop some stitches off your needle after you work them. That is a common mistake when first learning to knit. Or you may be doing a yarn-over between some stitches which adds stitches onto your needle. If you take a picture of your piece and post it here, someone may be able to look at it and help you figure out what you are doing wrong.

Don't give up though! Keep at it!

MGM
__________________
Mary Grace McNamara
www.HookedOnNeedles.com
I'm MaryGrace on Ravelry
I'm also HookedOnNeedles on Flickr!
And you can find me on Facebook too!
MGM is offline   Reply With Quote
Old 07-19-2010, 08:05 PM   #3
Jan in CA
Moderator
Mod Squad
 
Jan in CA's Avatar
 
Join Date: Oct 2005
Location: Southern CA
Posts: 37,134
Thanks: 1,655
Thanked 8,729 Times in 7,102 Posts
It could be a couple things. One is as Mary said you may not be knitting the stitch properly. Make sure after you wrap the yarn and pull it through that you slide the stitch off the needle. One stitch will remain. Watch the video at the tab at the top of the page. If you need still photos you can choose one of these -

Scroll down for still photos:
continental (holding the working yarn in your left hand)
english (holding the working yarn in your right hand)

You could also be doing accidental increases.
__________________
Jan

When asking questions ALWAYS post the name and a link for the pattern if you have it.

NEW! KH knitting video archive
~HOW TO POST A PHOTO~

Jan in CA is online now   Reply With Quote
Old 07-19-2010, 08:09 PM   #4
Krystal
Turning the Heel
 
Krystal's Avatar
 
Join Date: Sep 2006
Location: Windsor, Ontario Canada
Posts: 643
Thanks: 208
Thanked 134 Times in 106 Posts
I did the same thing when I first started. There are a lot of ways the extra stitches can pop on there as MGM listed.

For me, I was a very loose knitter in the beginning and I kept thinking the yarn between stitches was a dropped stitch because of how loose it was so I would pick it up and knit it... eventually I figured out that I had NOT dropped any stitches and stopped doing that and it solved the issue.

Not sure if you are doing this but I thought I'd throw it out there.


Keep at it though. When I was knitting my first scarf I just kept knitting past every error. It was a TERRIBLE scarf but I was able to see my errors and improve on them. One end of the scarf was horribly loose, and oddly wide and thin and full of errors, and the other end showed more consistency with my stitches and was all one width and no mistakes.
__________________
Krystal is offline   Reply With Quote
Old 07-20-2010, 04:56 AM   #5
hyperactive
Working the Gusset
 
hyperactive's Avatar
 
Join Date: May 2010
Location: Germany
Posts: 1,097
Thanks: 104
Thanked 237 Times in 219 Posts
my first idea would be:
count your stitches. If the number is the same as the cast on you are not adding stitches. Good thing, you shouldn't.

Then the question is: are you knitting the same tightness? you might be getting lose in your work. That could make all the difference. Are the stitches about the same "open and lose"? if so, that is not your problem so much, either (but it might be a minimal change from row to row.)

another frequent thing is: you might have done a very tight cast on. then the knitting is often more lose than the cast on and therefore the knitting flares out from the outer edge.
If that is your problem you would not get an increase in size anymore after you go a couple of inches further.
to fix that, though, I would pull it all out and cast on again (maybe with a different method? maybe with extra lose method (second needle)?)

Since I do not want to confuse you: I will give you tips on how to propperly fix the problem once you have identified the matter. Does any of the 3 things above happen?

- more stitches than in cast on?
- more and more lose knitting?
- flare after the cast on edge only?


do not worry, by the way, we all started small at some point!
hyperactive is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
My scarf keeps on getting wider savannaholeary How-to Questions 4 12-28-2011 01:39 AM
Would love to make this scarf wider nooniewaters How-to Questions 5 12-03-2011 11:49 PM
knitting something wider than your needle Ghostc4 How-to Questions 3 12-06-2010 05:27 AM
How can I make this wider? gcgrammy How-to Questions 3 08-31-2010 05:22 PM
Doubled DayFlower Lace Scarf Pattern (Wider Variation) oona Pattern Central 18 12-17-2005 12:29 PM

All times are GMT -4. The time now is 10:24 PM.