Reply
 
Thread Tools Display Modes
Old 01-20-2010, 03:46 PM   #1
HeatherKate
Casting On
 
Join Date: Jan 2010
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Casting on within a Pattern?
Hello!
I am wanting to start the Wave Hand Warmers pattern in the book One Skein Wonders, but both my mom and I are confused about one part of the pattern.
In the "Forming the Thumb Hole" Section it says to bind off 4 stitches in one row (ok..I get that), and then to cast on 4 stitches in the next row (???).
How do you cast on within a pattern?

Here's the exact pattern, if that helps:
NEXT ROW: P2, K4, P2, bind off 4, *P2, K4, repeat from *
NEXT ROW: P2, K4, P2, Cast On 4 (???), *P2, K4; repeat from *

Thanks for any help!
HeatherKate is offline   Reply With Quote

 

This advertising will not be shown to registered members. Join our free online community today!

Old 01-20-2010, 04:07 PM   #2
Jan in CA
Moderator
Mod Squad
 
Jan in CA's Avatar
 
Join Date: Oct 2005
Location: Southern CA
Posts: 36,977
Thanks: 1,637
Thanked 8,645 Times in 7,047 Posts
There are three easy cast on methods you can use for casting on in the middle of a project. Backward loop, cable cast on and knitted cast on. All three can be found in the video section under cast ons at the tab above.
__________________
Jan

When asking questions ALWAYS post the name and a link for the pattern if you have it.

NEW! KH knitting video archive
~HOW TO POST A PHOTO~

Jan in CA is online now   Reply With Quote
Old 01-24-2010, 10:50 PM   #3
miccisue
Turning the Heel
 
Join Date: May 2006
Posts: 581
Thanks: 67
Thanked 134 Times in 98 Posts
Somebody please HELP!!!!!

I have a pattern that uses 2 different size needles. The smaller ones are for the ribbing, then when you finish that, you knit x number of stitches onto the bigger needles, then cast on x number of stitches after that. I watched the videos over and over and over until I was sure I had it down, and proceeded to do the cast on. It turned out fine, but the stupid cast on stitches ended up on the small needle instead of the bigger one where it was supposed to be. What did I do wrong, and more importantly, how do I correct it?
Thanks in advance!!!!!!!!!!!!!!!!!!!!
miccisue is offline   Reply With Quote
Old 01-25-2010, 12:13 AM   #4
suzeeq
Knit On!
 
Join Date: Aug 2006
Location: Montana
Posts: 27,765
Thanks: 160
Thanked 6,450 Times in 6,035 Posts
Send a message via Yahoo to suzeeq
Without seeing how you did it, it would be hard to say. If you knita few stitches onto the larger one, you should have cast on the stitches to that needle. Transfer it to the left hand, cast on and then go on. Just watch it next time that you cast on to the larger needle.
__________________
sue- knitting heretic

suzeeq is offline   Reply With Quote
Old 01-25-2010, 09:47 AM   #5
miccisue
Turning the Heel
 
Join Date: May 2006
Posts: 581
Thanks: 67
Thanked 134 Times in 98 Posts
Originally Posted by suzeeq View Post
Without seeing how you did it, it would be hard to say. If you knita few stitches onto the larger one, you should have cast on the stitches to that needle. Transfer it to the left hand, cast on and then go on. Just watch it next time that you cast on to the larger needle.
I knit the 32 stitches from the #6 to the #8....this left the bigger needle in my right hand. But, when you watch the video, the cast on stitches end up on the LEFT needle (apparently I only realized that problem after I'd made the mistake and rewatched it....apparently that only works if both needles are the same size). That's how the cast on stitches ended up on the opposite needle from my 32 knitted on stitches.

Now, do I undo the cast on stitches and reverse the needle positions, or am I going to end up with the "knitting yarn" in the wrong place by doing that? No joke, my head is swimming at trying to figure out how to correct this. It seems like it should be fairly simple......just go back to where I messed up the first time....but my mind is playing with me and making me think I'll have other issues to deal with if I do that.

Somebody smarter and more experienced than me, please help me get my mind back on track.

Thanks!!!!!!!
miccisue is offline   Reply With Quote
Old 01-25-2010, 10:38 AM   #6
suzeeq
Knit On!
 
Join Date: Aug 2006
Location: Montana
Posts: 27,765
Thanks: 160
Thanked 6,450 Times in 6,035 Posts
Send a message via Yahoo to suzeeq
You have to switch the bigger needle to your left hand and cast on then. That's the needle where the working yarn is anyway. So yeah, go back, undo the cast on stitches, swap the hand your needle is in then cast on.
__________________
sue- knitting heretic

suzeeq is offline   Reply With Quote
The Following User Says Thank You to suzeeq For This Useful Post:
miccisue (01-25-2010)
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
casting off in pattern cmhoover1 How-to Questions 1 01-29-2012 12:59 AM
Casting On Mid Pattern KazooKnits How-to Questions 6 10-23-2008 11:09 AM
Casting on in a pattern kendallgailsmommy How-to Questions 2 03-02-2008 02:43 PM
Casting off within a pattern? fobles How-to Questions 1 01-20-2008 11:09 PM
casting on in pattern? brookenic How-to Questions 5 04-24-2005 01:18 PM

All times are GMT -4. The time now is 11:49 PM.