View Single Post
Old 02-08-2011, 10:24 PM   #17
1st Leg of the Journey
Mokumegane's Avatar
Join Date: Jan 2011
Location: Bethel Heights, AR
Posts: 245
Thanks: 0
Thanked 43 Times in 42 Posts
Send a message via AIM to Mokumegane Send a message via MSN to Mokumegane Send a message via Yahoo to Mokumegane
I would think anyone back then with enough money could get a master woodcrafter to make any size and shape knitting needles for them. As for metal ones, that would be difficult pre-industrial revolution. Possible but difficult, for sure. Maybe iron... cast iron. I haven't done a lot of reading on this yet, so don't quote me on it.

Actually, thinking of making metal needles is reminding me of the coat hooks I made just before Christmas. Really, to make something like that, they would either have to heat up and draw the metal through a round hole in another object that's harder than the toughness of the heated metal or they'd have to heat it and hit it with a hammer, turn, hit, etc. until it was the correct shape and thickness. If they used the second way of doing this, the created item would end up lumpy or square... even if just a little bit so.
Mokumegane is offline   Reply With Quote