View Single Post
Old 02-07-2013, 09:01 PM   #7
Working the Gusset
fatoldladyinpjs's Avatar
Join Date: Dec 2010
Location: Wisconsin near Green Bay
Posts: 1,567
Thanks: 157
Thanked 527 Times in 424 Posts
The problem with the standard k2, lift one over bind off listed above is that it looks wider than your cast on edge and flares out. The cast on and bind off don't match. I do this bind off but do P2 lift over instead. The bind off matches the cast on edge and they're about the same width when you're done. You might try that. It's especially helpful if you're doing a scarf. Someone who doesn't knit won't notice it, but we knitters are our own worst knitting police.
Welsh corgis are cool.
fatoldladyinpjs is offline   Reply With Quote